[TenTec] din connector, news from Hall Mountain KY

[Bob McGraw - K4TAX]

Seem to recall that Tentec has a "Y" type connector that will allow one to 
use two devices such as a soundcard and amp keying line.

Also, seem to recall the amp keying accessory {318} has a 2nd DIN that 
allows for amp keying delay plus a second accessory.

Might check with Paul in Service on this.

73
Bob, K4TAX


----- Original Message ----- 
From: "John" <k4avx1 at windstream.net>
To: <tentec at contesting.com>
Sent: Saturday, September 20, 2014 11:21 AM
Subject: Re: [TenTec] din connector, news from Hall Mountain KY


> Thanks to everyone for the info on the Din (not mini-DIN) connector on
> my Eagle.  I guess it's symptomatic that I would think the connector is
> smaller, since I'm older since I put one on!!
>
> I took early advice, went on E-Bay and found the amp line custom built.
> But I already have those pins connected on a crooked connector using
> one of Mike's amp keyers, which incidentally, works like a charm. Hope
> he can make them available again...
>
> On eBay, I found a male two ended 8 pin DIN cable at a reasonable price.
> It's on its way, and I can redo the amp circuit and make use of the
> other pins as needed, IF it has full wiring for all pins.
>
> In other news, death to my Omni 6+, as it just came back from the factory
> un-fixable.  Brain dead.  Can use the filters in the Corsair II, that I 
> put the
> DDS Vfo into.  It was a great rig.
>
> Learning more about the Eagle and I like it very much.  Worked two new
> DX countries last night, and plan to work the S.C. party today, perhaps
> the Scandinavian Contest if bands are decent.
>
> Thanks again for all the help,
>
> 73, John, K4AVX
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>