[TenTec] Model 544 (or that era) part source needed

Vic Klein vhklein at ptd.net
Wed Aug 5 09:28:54 EDT 2015


Ten Tec no longer has those, but a good replacement is available at Radio
Shack that has leads and fits into that space. It seems either the original
or the replacement was 6v, requiring a small wiring change to use the RS
parts (I cannot recall which way it went), but going from series to parallel
or vice-versa for the 2 bulbs is all it takes. There is a third bulb, of
course, that lights the knob skirt, but I don't recall if I replaced that
one. 

I had considered going LED as I have in other bulb replacements, but the
positioning of these 2 bulbs means the light comes off the side, not the
end, so an LED would provide zero illumination. I don't recall whether the
dial skirt lamp you need is positioned such that an LED could be used. It
has been a number of years since I made that repair to my Triton I, but
other than removing that panel it was pretty easy to do. The manual
specifies the original lamps that were used, so I used that when looking at
Radio Shack to see what could replace it. Somewhere here in the shack I
probably have more notes on that if needed.

=Vic=
WA4THR

----------------------------------------------------------------------------
--------------------
To: tentec at contesting.com
Subject: [TenTec] Model 544 (or that era) part source needed
From: k7mks at comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Date: Wed, 5 Aug 2015 03:02:03 +0000 (UTC)
List-post: <tentec at contesting.com">mailto:tentec at contesting.com>

Would appreciate knowing a source and voltage for the for the small grain of

wheat panel pilot light. Also need a source of the GREEN 10's digit LED. I 
suspect more than one TenTec model used these parts. 

Thank you Joe k7mks 



More information about the TenTec mailing list