[TenTec] How to Purchase Low-ESR Capacitors

[Kimberly Elmore]

I found it on the TenTec Wiki at  565pwrdistfail - TenTecWiki. There are variants, but Barry's was the the most recent. 


|   |
|   |   |   |   |   |
| 565pwrdistfail - TenTecWikiDetailed analysis by K7HP of the 81936 A9 Power Distribution Board - Orion 565 and Orion 566 OII (scroll down for latest advice) (posts from the Ten-Tec and Orion Reflectors) April 6, 2007  |
|  |
| View on tentecwiki.org | Preview by Yahoo |
|  |
|   |

Kim N5OP
      From: Froiseth Richard <Rfwd6dok at centurylink.net>
 To: Kimberly Elmore <cw_de_n5op at sbcglobal.net>; Discussion of Ten-Tec Equipment <tentec at contesting.com> 
 Sent: Tuesday, December 8, 2015 1:16 PM
 Subject: Re: [TenTec] How to Purchase Low-ESR Capacitors
   
Where can I get Barry’s Cap list?
73’sRich, WD6DOK









On Dec 8, 2015, at 10:41 AM, Kimberly Elmore <cw_de_n5op at sbcglobal.net> wrote:
I just replaced all the electrolytics on my O II A9 board with the recommended capacitors researched by Barry, N1 EU. As I looked in the Mouser catalog, I began to wonder: how can I determine which capacitors are the "low ESR" type? It doesn't always seem obvious to me. Is there something I'm missing? Do I simply use the ESR filter and select the lowest available ESR for the value I want?
Kim N5OP  
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec