[TenTec] Small issue with Orion II

[Carl Moreschi]

You could try to reset the battery save area.  Do all the following.

1) Power off Orion.

2) Power On holding the VFO B LCK button.

3) Continue holding LCK button until the radio says "Battery Failure".

4) Power off Orion.

5) Power on holding "Main RX/TX" button.

6) Continue holding this button until the radio says reset complete.

7) Do not clear any settings when asked to do so.

8) Power the Orion off and back on one more time.





Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 12/16/2015 10:03 AM, Mike Chatfield wrote:
>
> I have noticed a small issue with my Orion II. It may be an indicator of
> a larger issue. When I set my side-tone to zero and power off the Orion
> II and cycle power back on the side-tone setting goes to 522, everything
> is normal. I can reset it to 0 and it stays there. This happens every
> time I cycle power.
>
> I believe this a symptom of a flaky memory address. Does someone have
> some thoughts or seen this?
>
> Tnx for the help
>
> Mike Chatfield
> W0BBC
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>