[TenTec] Bias adjustment on Orion II

[Ron Castro]

I am planning on adjusting the driver and final bias on my Orion II, which is something I have never done.  I assume that the correct way to do it is by inserting an ammeter in the B+ to each of the two drivers (Q1, Q2) and to the pair of finals (Q3, Q4) and adjusting for the current shown on the schematic.  Would that be the correct way to proceed?

The last time it was at the factory, they found the bias out of adjustment and one of the pots bad.

Thanks,

          Ron Castro
           N6IE
    www.N6IE.com

Member:
                  ARRL
     Redwood Empire DX Assn.
 Northern California Contest Club
Northern California DX Foundation
  Society of Broadcast Engineers