[TenTec] Clifton Labs buffer amp i.f. output mod in Eagle?

[g3ory at lineone.net]

Guys,

I have been trying to contact Jack for some time now (since late 
September). He did mail me to say that he was taking a bit of a break 
but hoped to be active again at the beginning of November.  I have had 
no word from him since then.

73 Bob G3ORY

>----Original Message----

>From: n5mf at dfn.com
>Date: 19/12/2015 3:34 
>To: "jon greenwood"
<n8mus at yahoo.com>, "Discussion of Ten-Tec Equipment"<tentec at contesting.
com>
>Subj: Re: [TenTec] Clifton Labs buffer amp i.f. output mod in 
Eagle?
>
>I just tried to order one and they sent the money back 
because Jack is under 
>the weather.  That was 2 weeks ago.
>
>Mark

>N5MF
>
>-----Original Message----- 
>From: jon greenwood via TenTec

>Sent: Friday, December 18, 2015 7:38 PM
>To: tentec at contesting.com

>Cc: jon greenwood
>Subject: [TenTec] Clifton Labs buffer amp i.f. 
output mod in Eagle?
>
>Barry,
>
>I have a Clifton labs amp that I was 
wanting to install in my Corsair 2 9mhz 
>IF for a panadapter. Not to 
steal your thread but do you have any thoughts 
>as to where you would 
pull the IF out on the Corsair?
>73Jon N8MUS

>_______________________________________________
>TenTec mailing list

>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>---
>This 
email has been checked for viruses by Avast antivirus software.
>https://www.avast.com/antivirus>
>

>_______________________________________________
>TenTec mailing list

>TenTec at contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec>