[TenTec] Fwd: EAGLE and N4PY software issue

[David Perrin]

My apologies if this is a repeat:

> Begin forwarded message:
> 
> Subject: EAGLE and N4PY software issue
> From: David Perrin <dbperrin at gmail.com>
> Date: February 15, 2015 at 9:04:21 PM EST
> To: Tentec reflector <tentec at contesting.com>
> 
> Hi-
> 	 I have my older EAGLE connected to my Toshiba notebook (no serial ports) with a USB cable and the COM (UART) is at com12. I  get pretty good communication between the computer and the EAGLE, but one problem persists.
> 	The software misses the frequency of the EAGLE by 1.5MHz. Many times I have set the frequency of the EAGLE to 10MHz and the software to 10MHz, and I have fine tuned both to get the same pitch on both USB and LSB, I have A=B to both VFO’s, I have run the Calibrate routine. It all looks the same on the software and the EAGLE.
> 	As soon as I try to change the frequency of the software by sliding the tuner dial the EAGLE jumps frequency by 1.5 MHz to 8.5MHz. 
> 	What is up with that? Any ideas?
> 
> 73 de Dave, K1OPQ/4