[TenTec] Using a Mac to install OMNI VII firmware

[Clayton Brantley via TenTec]

I thought the Mac wouldn't work. 

Clayton N4EV

      From: Mike Bryce <prosolar at sssnet.com>
 To: Clayton Brantley <clayton_n4ev at yahoo.com>; Discussion of Ten-Tec Equipment <tentec at contesting.com> 
 Sent: Sunday, May 10, 2015 12:14 PM
 Subject: Re: [TenTec] Using a Mac to install OMNI VII firmware
   
Sorry to say, the mac’s won’t work. UNLESS you run “Parallels” a windows emulator

Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/ <http://www.theheathkitshop.com/>
J e e p
o|||||||o 

A man with one clock knows what time it is. A man with two clocks is never sure. 





> On May 10, 2015, at 11:39 AM, Clayton Brantley via TenTec <tentec at contesting.com> wrote:
> 
> You might check with the guys in Sevierville, but I don't think the updates will work with anythingBUT a Windows PC.  I use Linux as my main computer but I keep a PC around for what you aretaking about.
> Clayton N4EV
> 
>      From: "Silevitch, Michael" <m.silevitch at neu.edu>
> To: "TenTec at contesting.com" <TenTec at contesting.com> 
> Sent: Sunday, May 10, 2015 8:14 AM
> Subject: [TenTec] Using a Mac to install OMNI VII firmware
> 
> I have just purchased an OMNI VII and will be updating the firmware. I would prefer to use my Mac computer rather than a PC for this. I have a serial to USB adapter which should work to connect the OMNI to the Mac (or PC for that matter.) Any guidance would be appreciated. 
> 
> I may also want to operate the OMNI remotely using a Mac rather than a PC. Again any advice would be appreciated. 
> 

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec