[TenTec] Using a Mac to install OMNI VII firmware

[Duane Calvin]

Have a friend with a Windows laptop?  Just work out a swap - three fingers
of Redeye for a few minutes to install!  :-)

	73, Duane

Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com  




-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of denton
sprague
Sent: Sunday, May 10, 2015 11:37 AM
To: Clayton Brantley; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Using a Mac to install OMNI VII firmware

Sad to say, but there is still very little ham software available for Macs.
For now the only apparent alternative is to keep a dedicated windoze pc
available for ham software use.


On May 10, 2015, at 9:24 AM, Clayton Bra4P via TenTec
<tentec at contesting.com> wrote:

> I thought the Mac wouldn't work. 
> 
> Clayton N4EV
> 
>      From: Mike Bryce <prosolar at sssnet.com>
> To: Clayton Brantley <clayton_n4ev at yahoo.com>; Discussion of Ten-Tec
Equipment <tentec at contesting.com> 
> Sent: Sunday, May 10, 2015 12:14 PM
> Subject: Re: [TenTec] Using a Mac to install OMNI VII firmware
> 
> Sorry to say, the mac’s won’t work. UNLESS you run “Parallels” a windows
emulator
> 
> Mike, WB8VGE
> SunLight Energy Systems
> The Heathkit Shop
> http://www.theheathkitshop.com/ <http://www.theheathkitshop.com/>
> J e e p
> o|||||||o 
> 
> A man with one clock knows what time it is. A man with two clocks is never
sure. 
> 
> 
> 
> 
> 
>> On May 10, 2015, at 11:39 AM, Clayton Brantley via TenTec
<tentec at contesting.com> wrote:
>> 
>> You might check with the guys in Sevierville, but I don't think the
updates will work with anythingBUT a Windows PC.  I use Linux as my main
computer but I keep a PC around for what you aretaking about.
>> Clayton N4EV
>> 
>>       From: "Silevitch, Michael" <m.silevitch at neu.edu>
>> To: "TenTec at contesting.com" <TenTec at contesting.com> 
>> Sent: Sunday, May 10, 2015 8:14 AM
>> Subject: [TenTec] Using a Mac to install OMNI VII firmware
>> 
>> I have just purchased an OMNI VII and will be updating the firmware. I
would prefer to use my Mac computer rather than a PC for this. I have a
serial to USB adapter which should work to connect the OMNI to the Mac (or
PC for that matter.) Any guidance would be appreciated. 
>> 
>> I may also want to operate the OMNI remotely using a Mac rather than a
PC. Again any advice would be appreciated. 
>> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec