[TenTec] ALS 600, TT Orion and Omni 7

[denton sprague]

got the amp yesterday and its up and running…works fb…except for slight glitch on 160 meters..keeps wanting to go into fault mode if anything over 400 watts out to the antenna.
works fb on dummy load though.
antenna is short for 160 so that might be part of the problem.
Is there an interface cable to allow my Orion and/or Omni 7 to allow either rig to select the ale 600’s bandpass filters?
I was informed not to interface alc cable between the rig and amp…any comments on this? thanks…

On May 20, 2015, at 7:59 AM, Rick - DJ0IP / NJ0IP <Rick at DJ0IP.de> wrote:

> With SSB, NONE.
> 
> With CW, well two potential problems.
> The relay in the ALS-600 is very slow - about 20ms on average - despite
> Ameritron's claim of 15 ms.
> You need to add some time sequencing.
> 
> Unfortunately the 15mS pre-dit delay is fixed and not adjustable, but it
> goes a long ways in protecting the relay on the front end.
> 
> You also need to add a couple hundred ms of hang delay.  The OM7 has a menu
> item where you can do this but by default it is turned off (set to 0).  If
> my memory serves me right, I believe it adjusts in increments of 50ms.
> It's been 7 or 8 years since I have operated an OM7.
> 
> But as I said, with SSB it's not really an issue, especially when running
> PTT.
> Even with vox it's not as bad as CW because the voice starts soft and rises,
> so the initial blast of RF is at low power (unless you sneeze!)
> 
> I had an ALS-600 for a few years and it is a very nice amp.
> If you are serious about CW, Phil Salas, AD5X has two different mods to the
> relays.  You might want to try one or the other.
> 
> 73 - Rick, DJ0IP
> (Nr. Frankfurt am Main)
> 
> 
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of denton
> sprague
> Sent: Wednesday, May 20, 2015 4:46 PM
> To: Discussion of Ten-Tec Equipment
> Subject: [TenTec] ALS 600, TT Orion and Omni 7
> 
> Got a used Ameritron ALS 600 coming in the mail this friday. Anyone have any
> problems running one with either an Orion or Omni 7?
> I plan on driving the amp with no more than 50 watts, primarily on 160 and
> 80 meter ssb.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec