[TenTec] Ten Tec Orion 11 transciever

[Barry N1EU]

Get a simple "Y" adapter to plug in the headphone jack and run a cable to
your soundcard input or an external recording device.  There's lots of free
soundcard software out there that will do a 48-hour recording and break it
into smaller chunks.  I believe the recording is only required if you place
in the overall top 3 in the single op unassisted category, so it's not
something many of us worry about.

Barry N1EU

On Mon, Oct 12, 2015 at 2:22 AM, Bill Johnson via TenTec <
tentec at contesting.com> wrote:

>
> What is the best way to comply with the new CQ WW requirement to create an
> MP3 sound file of the contest from my Orion 11 transceiver?  I see the
> audio out jacket on the back of the Orion 11 however it does not provide
> the transmit audio for the MP 3 file?
>
> Bill KV0Q
>
>
> -----Original Message-----
> From: Ken, W8EK <kenw8ek at gmail.com>
> To: TenTec List at contesting <tentec at contesting.com>
> Sent: Sun, Oct 11, 2015 5:22 pm
> Subject: [TenTec] Misc TenTec items FS
>
>
>
> TenTec Wall Wart, 25 amp power supplies, Cables, and other
> miscellaneous
> accessories For Sale:
>
>
> TenTec Model 48-15-800 D "Wall Wart":
>
> This wall wart is
> the "regular" linear type, and not the
> switching type that creates electrical
> noise.  It is rated
> at 15 V DC at 800 ma, and is used on a variety of
> TenTec
> items.
>
> It works fine and looks like new.  $15
>
>
> 25 Amp Power Supplies,
> ideal for most any HF rig:
>
> All are rated at 25 amps, work fine and look great,
> and
> include paper work.
>
> Pyramid Phase III, PS-25
> This power supply will furnish
> up to 25 amps. The voltage
> is adjustable from the front panel from 4.5 to 15 V
> DC.
> It includes both an ammeter and a voltmeter on the front panel.
> It would be
> ideal for the bench as well as for powering a rig.
> This unit may be new. It is
> still in its original box, with the
> packing material and paper work. $100
>
> Radio
> Shack 22-510 is a 13.8 V DC switching power supply
> rated at 25 amps continuous
> duty. Note the 100% duty cycle
> rating! It should easily power most any modern HF
> transceiver.
> It is small and relatively light weight.
> This unit works 100%, and
> looks extremely nice -- close to new.
> It includes paper work -- operating
> manual, parts list, schematic,
> and circuit board layout. $65
>
> MFJ 4225 MV, 22
> amp Continuous Power Supply:
> This is a rugged, but light weight power supply
> that will power
> most anything in your shack, whether an HF rig, or VHF and
> UHF
> rigs. Electrically, it is extremely quiet. I could find
> no
> noise.
> Specifications:
> 25 Amps Surge, 22 Amps Continuous at 13.8 Vdc
> Front
> Panel Adjustable Voltage (9-15 Vdc)
> Lightweight, only 4.2 lbs.
> Compact, only 5
> ¾" W x 4 ½" H x 6" D
> Two output connections:
> Five-Way binding post for HF/VHF
> radio
> Cigarette Lighter Socket for mobile accessories
> Over Voltage
> Protection
> Over Current Protection
> Automatic Reset after shutdown
> LIGHTED Dual
> Meters:
> Volt-meter and Amp-meter monitor load continuously
> Quiet internal
> Cooling Fan with "Fan On" LED
> This one works fine and looks like new.
> Complete
> with paper work for $70.
>
>
> Cable for Hercules 444 Amplifier
>
> This cable is used
> to connect the Hercules (Original 444) to
> its power supply.  Heavy duty cable,
> with heavy Molex type
> connectors on each end.  Nice condition.  $25
>
>
> VOX board
> for TenTec 262 Power supply
> Ready to plug in to replace your defective
> board.
> $10
>
>
> TenTec 715-I cable
> This cable is made to plug into the TenTec 715
> RF Speech Processor
> on one end, and an Icom transceiver at the other end.  This
> is
> the round 8 pin mic connector used on Icom rigs such as the IC-735,
> 756
> series, and many others.  It is NOT for the type that takes the
> modular
> plug.
> This one works fine and looks like new.  $18
>
>
> TenTec 720 adapter
> Adapts
> an Icom microphone with the round 8 pin connector to a rig
> requiring the TenTec
> / Yaesu round 8 pin connector.  Like new. $15
>
>
> Cables for CW keyers and
> keys:
>
> Cable for paddles
> About 3 feet long, and with a 1/8 inch (3.5 mm)
> stereo
> connector on the end, like used by most rigs. $8
> As above, but 1/4 inch
> plug. $8
>
> Cable for straight key
> About 3 feet long, with a mono 1/8 inch (3.5
> mm) phone
> plug on it, as used with a straight key. $5
> As above, but 1/4 inch
> plug. $5
>
>
> I also have many other accessories available such as many
> different
> types of microphones, HTs, VHF and UHF rigs,
> antennas, etc. Just too many things
> to list here.
> Please e-mail your requests.
>
>
> Prices do not include shipping from
> Florida.
>
>
> Thanks.
>
> 73,
>
> Ken, W8EK
>
> Ken Simpson
> E-mail to W8EK at FLHam.net or
> W8EK at arrl.net
> Voice Phone  (352)
> 732-8400
>
>
>
>
> _______________________________________________
> TenTec mailing
> list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>