[TenTec] Orion sub receiver getting no signals

[denton sprague]

a little followup..
sub rx was inoperable this am…booted up with sub rx on ant 1 and vfo b enabled yesterday.

after letting the rig on for about 3 hours, I rebooted the rig with sub rx off on the ant and vfo buttons. 

after reboot, enabled sub rx on vfo b and ant 1 buttons. Sub rx now works normally….

On Oct 11, 2015, at 11:27 AM, denton sprague <denton at oregontrail.net> wrote:

> thanks…apparently that was it om!!
> On Oct 11, 2015, at 11:13 AM, Tim Wininger <ky5rtim at gmail.com> wrote:
> 
>> Need both SUB RX VFO and Ant1 SUB RX depressed.
>> 
>> That's how I use this sub rcvr hr. Hope it's just that.
>> 
>> GD Tim, AB4B
>> 
>> On Sun, Oct 11, 2015 at 12:01 PM, denton sprague <denton at oregontrail.net>
>> wrote:
>> 
>>> 
>>> Hi all…my trusty Orion that came back from TT for processor board
>>> replacement a few months ago seems to have no  receive signals…this
>>> happened this am when booting up the rig.
>>> I use ant 1 as main rx/tx as well as sub rx.
>>> I can hear the sub noise come up when pressing the sub rx button, but
>>> evidently getting no signals from the antenna.
>>> I have only one hf antenna.
>>> Did a master reset to no avail.
>>> loose cable maybe??
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec