[TenTec] [Ten Tec} Corsair II weak weak receive

[jon greenwood]

Update on Corsair: replaced all the pin diodes. Before putting Q6 back tested voltages again per Steve's suggestion. Still reading 11.52V at both points Steve suggested to measure. Have not reinstalled Q6. Can't figure out what is causing the high voltage readings.???Jon
 


     On Sunday, October 11, 2015 1:33 AM, Steve Hunt <steve at karinya.net> wrote:
   

 Jon,

One other check you might want to make while Q6 is removed: on Rx, 
measure the voltage at the R32/R33 junction, and the voltage at the 
R31/R32 junction; they should be around 1.7v and 9.5v respectively.

Steve G3TXQ


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec