[TenTec] Push Buttons

[Gary J FollettDukes HiFi]

If all else fails, I have two spare encoders.

Gary



> On Oct 25, 2015, at 2:02 PM, Barry N1EU <barry.n1eu at gmail.com> wrote:
> 
> This can be a simple mechanical issue.  First I'd try pulling off the
> chrome collar, loosening the set screw on the knob and repositioning the
> knob slightly further out from the front panel.  This allows more motion of
> the shaft switch.  Retighten and see if that makes a difference.
> 
> If not, it can also be the white nylon nut threaded on the encoder shaft
> being too tight.  This requires some disassembly of the front panel to
> correct.  But has anybody worked behind the front panel of his Orion?
> 
> Barry N1EU
> 
> On Sun, Oct 25, 2015 at 6:19 PM, Arthur Lewis <wa8vsj at gmail.com> wrote:
> 
>> *I have a friend with an Orion (565) that the push buttons on the Cut &
>> PBT/BW do not work. The CUT is in the low position and the PBT/BW is in the
>> BW position. When I push either buttons the positions do not change.  The
>> BW and the LOW CUT knob work fine. Just can't change to the PBT or the HIGH
>> CUT.  The rest of the Orion works fine. *
>> 
>> *Art WA8VSJ*
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec