[TenTec] Hercules II AMP Fault Setting

John Hecht k6koi at att.net
Thu Apr 21 15:23:13 EDT 2016


I just sold a Hercules II amp, which faults at 60 watts in and 375 watts out.The SWR during testing was 1:1,  the output coax was kept under 3 feet and a 50 ohm passive load was used for the test.  I suspect that there are potentiometer settings in comparator circuits for input and output and that either (or both) may be out of adjustment.  Am I correct about there being adjustments?  Would the pots be on the Control Board?  Where? 


More information about the TenTec mailing list