[TenTec] power switch for Tentec 961 power supply: follow up

[Allan Taylor]

Ignore my previous request for information. I had never paired the Corsair
II
with the 961... and forgot that the OmniVI formerly used has a jumper
in place between the two wires carrying a.c....

Allan  K7GT

On Sun, Aug 14, 2016 at 3:47 PM, Al Gulseth <wb5jnc at centurytel.net> wrote:

> Correction to my last post: the front panel switch is a push in/pull out,
> not
> push on push off. SRI about that, brain rebooting HI HI!!
>
> 73, Al
>
> --- previous message ---
>
> Allan,
>
> Just to make sure - remember that the switch is in series with the front
> panel
> switch on the rig. The push on - push off type switches used in the older
> rigs (Tritons, early Omnis, Delta, Argosys, and Corsairs) were prone to
> failure. You might check that and also the cable connections first.
>
> 73, Al
>
> On Sun August 14 2016 5:24:14 pm Allan Taylor wrote:
> > Guys,
> >
> > My Tentec gear has sat for a year or two during a shack renovation. While
> > trying to bring the Corsair II up recently, I
> > found that the 961 power supply did nothing (nada) when toggling the
> power
> > switch.Thinking that it is the most likely
> > candidate for the problem, I wonder if any of the gang knows the mfgr and
> > part number for a replacement switch.
> >  (I have not contacted TT but suspect the switch is not a one off design
> > for TT only!).
> >
> > Anyone?
>



-- 
73     Allan    K7GT