[TenTec] Paragon 1 and 2 Meter Replacement

[Gary J FollettDukes HiFi]

Yes.

There are no long shafts on this radio so the hinging process is actually very easy.

Gary



> On Aug 24, 2016, at 9:49 PM, k7mks at comcast.net wrote:
> 
> Gary: By "hinge" do you mean remove the 4 screws , one in ea corner of the panel 
> 
> , and hinge the panel, knobs etc knobs etc downward until I can unfasten the meter etc, Joe k7mks 
> ----- Original Message -----
> 
> From: "Gary J FollettDukes HiFi" <dukeshifi at comcast.net> 
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com> 
> Sent: Wednesday, August 24, 2016 7:08:10 PM 
> Subject: Re: [TenTec] Paragon 1 and 2 Meter Replacement 
> 
> You do need to hinge the panel down but this is pretty easy to do with an Omni 6 or paragon. 
> 
> Gary 
> 
> 
>> On Aug 24, 2016, at 5:21 PM, k7mks at comcast.net wrote: 
>> 
>> Does the front panel need to be removed, or is there an easier, way to replace the meter? What are the steps to access the meter. 
>> 
>> Joe k7mks 
>> _______________________________________________ 
>> TenTec mailing list 
>> TenTec at contesting.com 
>> http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec at contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec