[TenTec] Paragon I PLL

[Al Gulseth]

Cold solder joints? Not just Paragons, but Corsairs, Delta IIs... almost any 
of the older TT rigs, probably other brands as well, along with various 
automobiles (ask me how I know!) and most any other electronic device which 
isn't fresh out of the box.

73, Al

On Fri August 26 2016 2:43:24 pm Carl Moreschi wrote:
> This is a common problem with Paragons.  The fix is to remove the PLL
> board and reflow all the solder joints on that board.  The problem is
> cold solder joints that don't show up until much later in the radio's life.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 8/26/2016 3:01 PM, k7mks at comcast.net wrote:
> > In past 2 days my Paragon, after having been turned OFF for several hours
> > up to overnight, has experienced 2 failures of PLL locking. In each
> > instance, after turning on the Paragon, i pressed the RESET button and
> > normal operation for hours, in all respects (mode and band changes) plus
> > power output, was returned
> >
> > This is a cosmetically excellent radioi with all fllters and a Giehl chip
> > The "P" word has not entered the picture yet but my comfort zone with
> > PLL's is zero. Would appreciate helpful comments to help keep this radio
> > in one piece!
> >
> > Thank you Joe k7mks
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec