[TenTec] TenTec Eagle ACC1 "Y" splitter

K 5 T X T K5TXT at outlook.com
Thu Dec 1 13:45:30 EST 2016


TenTec Eagle ACC1 "Y” splitter

On the TenTec Eagle ACC1 DIN accessory connector there are pins for AMP KEY (8) and LINE_IN/OUT (1/2).
See: http://www.tentec.com/wp-content/uploads/2016/05/tt_599_manual_v1.009.pdf#page=23

Seems there should be no reason why AMP KEY and LINE_IN/OUT cannot be used simultaneously if one wanted to run digital modes AND key the amp (not a usual practice of course). Or just for the convenience of not swapping cables.

The TenTec 318 Amp Keying Interface has these dual DIN sockets too, but adds other features not needed at the moment.

So planning to use a DIN “Y” splitter cable (such as this: http://preview.tinyurl.com/MWRYCRET)
Any reason this would not work? Thanks.

Ryan, K5TXT






More information about the TenTec mailing list