[TenTec] Centaur metering question

[km2km at twc.com]

Joe,

My Centaur also reads low in the forward position compared with an external watt meter.  I am not sure what the Ig reality is, but I have ignored the "issue".   I just tune up as per the instructions and figure that it is tuned well with max output and do not exceed the plate current.

It will be good to see others' comments on this issue.


Kris KM2KM 
MERSCHROD
123 Warren Road
Ithaca, NY 14850

---- Joe Papworth via TenTec <tentec at contesting.com> wrote: 

=============
 The "FWD" meter reads low as compared to my in-line watt meter, which I know is accurate.
I'm OK with that but I'm concerned about the grid current reading, since it uses the same meter and switch. (I've seen a lot of scuttle-butt about the metering switches being a problem)
Any input is welcome.


Later, Joe, K8MP

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec