[TenTec] Ten Tec Phone number? A9 caps.

[Froiseth Richard]

Is there a phone number that I can contact Ten Tec on... or are they not taking calls?
I ordered the caps for the A9 board and they did not send one.  Maybe this cap does not need replacing.  100uf 6.3v loc c8-3.
I assume all of the caps should be replaced… true.
Any help would be appreciated… or should I order one from Digi-Key or elsewhere.


73’s
Rich, WD6DOK







> On Jan 18, 2016, at 4:44 PM, Carl Winkles <jcwinks at att.net> wrote:
> 
> You might check the power connector on the rear of the Herc II. I have had bizarre things happen when fewer than all of those pins are making contact.
> 
> Carl, K4SEV
> 
> Enviado desde mi iPhone
> 
>> El ene 18, 2016, a las 5:29 PM, Zivney, Terry <00tlzivney at bsu.edu> escribió:
>> 
>> 
>> My Hercules II  was working but now..
>> 
>> 
>> 
>> 
>> On power up (with matching TenTec power supply) the front
>> 
>> panel fault light comes on as does the fan.  Waiting a few
>> 
>> seconds, the red led fault light dims out and the fan stops,
>> 
>> but the meter lights still have full brightness.  The amp
>> 
>> does not switch over to XMT (a good thing, without the blower!)
>> 
>> 
>> 
>> 
>> Any ideas what to check first?
>> 
>> 
>> 
>> 
>> Terry N4TZ
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec