[TenTec] Paragon vs Paragon II - PLL

[Bwana Bob]

I believe that they redesigned the PLLs for the Paragon II.  The main 
issue with the PLL boards in the original Paragon was poor tinning of 
the component leads and the PWB.

             73,

             Bob WB2VUF

On 1/19/2016 9:29 PM, Gary J FollettDukes HiFi wrote:
> I can’t speak insider facts here but I have had many Paragon 2 radios and none of them had PLL issues.
>
> Gary
>
>
>
>> On Jan 19, 2016, at 5:17 PM, steve jobes via TenTec <tentec at contesting.com> wrote:
>>
>> I have not had any problems with my paragon 2, and can't recall hearing of any issues with them.
>>
>> 73,
>> Steve W1DXH
>>
>>
>>
>>
>>
>>
>>
>> -----Original Message-----
>> From: k7mks <k7mks at comcast.net>
>> To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
>> Sent: Tue, Jan 19, 2016 6:14 pm
>> Subject: [TenTec] Paragon vs Paragon II  - PLL
>>
>> Did Ten Tec make any performance improvements (ie soldered board conections, etc) in the later #586 PLL over the earlier #585 PLL's ?
>>
>> Thank you. joe k7mks
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec