[TenTec] OMNI-D Display

[Carl Moreschi]

That's the frequency you get when the VFO stops running. You also get 
this when you unplug the VFO jumper in the back of the radio.  I would 
unplug and replug this jumper a few times to clean it and see if that 
corrects the problem.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 1/24/2016 10:28 AM, Frederick Kilburn via TenTec wrote:
> The display on my OMNI-D is fine on all bands except after warm up
> the 28MHZ display changes to 9MHZ. The output frequency remains correct.
> Ideas anyone?
>                                 TN X
>                                         FRED  W2VUF
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>