[TenTec] Orion encoders both sold

[Gary Follett]

Yeah, they really are a pain...

I found that a well focused heat gun works best to melt the solder on all of the pins, then  I snap the board against the edge of my work bench to fling the melted solder out of the  holes. The encoder will often come out with the same fling but will certainly come out with gentle tugging.

Sent from my iPad

> On May 17, 2016, at 8:22 AM, Barry N1EU <barry.n1eu at gmail.com> wrote:
> 
> Good luck installing them.
> 
> 73, Barry N1EU
> 
> On Mon, May 16, 2016 at 10:05 PM, Gary J FollettDukes HiFi <
> dukeshifi at comcast.net> wrote:
> 
>> Let know if they work OK.
>> 
>> They are 100% guaranteed.
>> 
>> Gary
>> 
>> 
>>> On May 16, 2016, at 9:02 PM, A R <raf_3 at msn.com> wrote:
>>> 
>>> 
>>> Gary,
>>> 
>>> 
>>> 
>>> Received the encoders today in great condition.
>>> 
>>> 
>>> 
>>> Thanks and 73,
>>> 
>>> Allen--W7GIF
>>> 
>>> 
>>> ----- Original Message -----
>>> 
>>> From: Gary J FollettDukes HiFi<mailto:dukeshifi at comcast.net>
>>> 
>>> To: Discussion of Ten-Tec Equipment<mailto:tentec at contesting.com>
>>> 
>>> Sent: Saturday, May 14, 2016 10:00 AM
>>> 
>>> Subject: [TenTec] Orion encoders both sold
>>> 
>>> 
>>> 
>>> The Orion encoders are sold.
>>> 
>>> Gary
>>> 
>>> 
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec