[TenTec] Orion 565 XMIT alignment

[art N4UC]

Thanks to both of you. It should have been straightforward but for some reason I wasn't having any luck. This helps a lot.


73, Art N4UC


________________________________
From: TenTec <tentec-bounces at contesting.com> on behalf of Mike Schatzberg <cherokeehillfarm at earthlink.net>
Sent: Saturday, November 5, 2016 4:14 PM
To: n4py3 at earthlink.net; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion 565 XMIT alignment

The information in the manual for adjusting the alc level with the led is incorrect also.

You will have no problem with the speech processor either if you adjust everything as per the article.

Amateurs complained about the average power output of the Orions for years until they started to set up their radios as described.

Good luck I'm sure you will have no issues.

73,

Mike
W2AJI

Sent from my iPhone

> On Nov 5, 2016, at 4:48 PM, Carl Moreschi <n4py3 at earthlink.net> wrote:
>
> Art,
>
> I believe you are correct.  I would set the ALC pot for 100 watts and not 110.  The power indicator is supposed to read watts and not percentage.  If you exceed 100 watts, you signal will start to have more IMD.
>
>
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com<http://www.n4py.com>
[http://www.n4py.com/uploads/3/7/9/4/3794564/4798460.jpg?343]<http://www.n4py.com/>

N4PY Software - Home<http://www.n4py.com/>
www.n4py.com
N4PY Software is your source for high quality, effective rig control software for your transceiver. N4PY offers rig control software for a wide variety of receivers ...


>
>> On 11/5/2016 3:02 PM, art N4UC wrote:
>> Thanks a lot Mike, that answers the ALC aspect of the question. Just for clarification though, you say to set the ALC SET to where the actual RF output as measured by an external wattmeter is about 110% of the pwr setting on the front panel. In this case you're looking for 110W on the external meter, correct?  Is the number on the front panel (100 in this case) supposed to represent power output in watts or percentage of maximum output? Is this possibly where the PWR pot comes into play, to adjust power output reading on the analog meter?
>>
>>
>> ________________________________
>> From: TenTec<tentec-bounces at contesting.com>  on behalf of Mike Schatzberg<cherokeehillfarm at earthlink.net>
>> Sent: Saturday, November 5, 2016 7:11 AM
>> To: Discussion of Ten-Tec Equipment
>> Subject: Re: [TenTec] Orion 565 XMIT alignment
>>
>> Take a look on my page.  It was written for the 566 and may help.
>>
>>
>> http://home.earthlink.net/~cherokeehillfarm/id2.html
[http://home.earthlink.net/~cherokeehillfarm/sitebuildercontent/sitebuilderpictures/mvc-018f.jpg]<http://home.earthlink.net/~cherokeehillfarm/id2.html>

AMATEUR RADIO STATION W2AJI - EarthLink<http://home.earthlink.net/~cherokeehillfarm/id2.html>
home.earthlink.net
Welcome to W2AJI, Tryon, North Carolina. First licensed in 1961, this year marks 50 years of continuous operation of W2AJI. Mike has been associated with the wire ...


>> [http://home.earthlink.net/~cherokeehillfarm/sitebuildercontent/sitebuilderpictures/mvc-018f.jpg]<http://home.earthlink.net/~cherokeehillfarm/id2.html>
>>
>> AMATEUR RADIO STATION W2AJI - EarthLink<http://home.earthlink.net/~cherokeehillfarm/id2.html>
[http://home.earthlink.net/~cherokeehillfarm/sitebuildercontent/sitebuilderpictures/mvc-018f.jpg]<http://home.earthlink.net/~cherokeehillfarm/id2.html>

AMATEUR RADIO STATION W2AJI - EarthLink<http://home.earthlink.net/~cherokeehillfarm/id2.html>
home.earthlink.net
Welcome to W2AJI, Tryon, North Carolina. First licensed in 1961, this year marks 50 years of continuous operation of W2AJI. Mike has been associated with ...


>> home.earthlink.net
>> Welcome to W2AJI, Tryon, North Carolina. First licensed in 1961, this year marks 50 years of continuous operation of W2AJI. Mike has been associated with the wire ...
>>
>>
>>
>> 73,
>>
>> Mike
>> W2AJI

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
TenTec Info Page - Contesting<http://lists.contesting.com/mailman/listinfo/tentec>
lists.contesting.com
Welcome to the Ten-Tec mailing list! This list is intended for the exchange of information on Ten-Tec-related topics ONLY. Off Topic subject postings should be ...