[TenTec] TX Audio Problems With Corsair II

[k8mp at aol.com]

Hi Steve. I'm wondering if it might be RF feedback or something else on the audio-in line. 
Do you have an RF watt meter in your feedline? And if so, was it showing output even when you weren't talking into the mic?
I saw a similar thing once on my Omni 6 Plus.
Turned out I had left my sound card line-out cable plugged into the audio-in on the rig after a RTTY contest.

<div>Later, Joe, K8MP
<div>
Sent from AOL Mobile Mail


-----Original Message-----
From: Steve Berg <wa9jml at frontier.com>
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Sent: Sun, Nov 13, 2016 04:25 PM
Subject: Re: [TenTec] TX Audio Problems With Corsair II


I fired up my Corsair II to check into the Ten Tec nets today. It 
receives fine, but when I tried to transmit on SSB, the ALC light lit up 
solidly, and it took backing way down on the drive level to make it 
stop.  I haven't used it much this summer, but I had it on for about 5 
hours before the net times.  Luckily, I was able to check in on the 20 
meter net with my Argo VI barefoot.

This is a new problem with the radio, so where might I start looking?


73,

Steve WA9JML

_______________________________________________
TenTec mailing list
<a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
</div></div>