[TenTec] Help with Tentec Omni 5

[Radio AI2Q]

Doc, first check the seating of the small 2-pin connector on the audio board 
at the top of the chassis.

In your troubleshooting, always work back from the speaker towards the audio 
amplifier, then the audio preamp, etc.

You can inject noise with a small screwdriver touched by your finger. Be 
cautious so you don't inadvertently short anything nearby.  The schematic is 
your friend.

Vy 73, AI2Q, Alex
Member: ARRL, FOC, RSGB, CWops, QRP-L, Antique Wireless Association, New 
England Radio Discussion Society, DXCC Honor Roll, 16ØM DXCC, 8ØM DXCC
http://ai2q.org


----- Original Message ----- 
From: "Doc" <k0evzdoc at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Tuesday, October 18, 2016 11:38 PM
Subject: [TenTec] Help with Tentec Omni 5


>I apologise in advance if I have inadvertently sent this note twice.  But
> maybe someone can help me with an ailing Tentec Omni 5.
>
> It has the matching power supply.  I turn on the rig it and everything
> lights up....but there is no audio from the rig.  This is true whether
> through the built-in speaker or the separate speaker.
>
> Can anyone offer some guidance?  It would be much appreciated, thanks.
>
> 73,
> Doc/K0EVZ
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 2016.0.7859 / Virus Database: 4664/13236 - Release Date: 10/19/16
>