[TenTec] Omni D wiring
kb1ckt at yahoo.com
Sat Dec 30 19:42:50 EST 2017
I'm rehabbing an older Omni D (Series B) and it looks like the wiring on the VOX board is wrong. VOX is 80451. It looks like I have the following:-red (12V)-white with orange stripe (speaker)-white with yellow stripe (? T/R?)-coax marked as #3 (mic?)
I think I'm missing a GND (can't find where this board gets GND from) and there is one solder terminal that is unused.
Anyhow: I had to lift the speaker connection to this board as it is clamping to 60mV of audio, so it's clearly miswired. This is a used radio, and I know 100% for sure that the PTO was removed, although the wiring on this VOX board looked unmolested--but one never knows.
I'd open up my Omni C but at the moment it's buried behind this D! Might someone have a pic or know what I should look for?
More information about the TenTec