[TenTec] Omni VI+ no output on 20 m

[k8mp at aol.com]

Hi Stan,
Replace both 20M relays on the low pass filter board. 99.9% chance that'll fix it.

Later, Joe, K8MP

Sent from AOL Mobile Mail


-----Original Message-----
From: Stan Lloyd <kd8ln.stan at gmail.com>
To: tentec <tentec at contesting.com>
Sent: Sun, Feb 19, 2017 09:50 PM
Subject: [TenTec] Omni VI+ no output on 20 m


Hi,

I have an Omni VI+ that has stopped putting out any power on 20m in any mode. It switched into transmit mode, and in CW It generates the side tone, but based on the internal meter and an external power meter it gives absolutely zero power output. It transmits fine with regular output on the other bands. Any ideas on how to approach this? 

I did try resetting the microprocessor, but no change. 

Thanks and 73,

Stan KD8LN


Stan
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>