[TenTec] Tapping a Delta II for a panadaptor?

Carl Moreschi n4py3 at earthlink.net
Tue Jan 31 18:32:48 EST 2017


My software keeps both radios on the same frequency.  It allows you to 
click on the panadapter display and have the radio instantly go there. 
And as you tune the radio, the panadapter radio will follow it.  It 
works really well this way.

73,

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 1/31/2017 5:57 PM, Bill Cotter wrote:
> Carl,
>
> Using the method you propose (parallel receiver), how do you make the
> SDR track the received frequency so that it signal heard is always
> centered in the panadapter view?
>
> 73 es tnx Bill N4LG
>
>
>
>
> At 10:14 PM 1/29/2017, you wrote:
>> I thought the QST article for panadapters was very poor. It
>> recommended using the IF to feed the panadapter. This is an archaic
>> method. Today with the SDR receivers available such as SDRplay, much
>> better results can be obtained without the need for an IF tap. These
>> new SDR receivers (such as SDRplay) can receive over a wide frequency
>> range typically from 50 khz to well over 30 mhz.
>>
>> Because of this, the most modern hookups now just involve connecting
>> the SDR receiver to the same antenna as the main radio and running
>> them in parallel with the main radio. This gives a much wider and more
>> versatile panadapter than being stuck with the radios IF.
>>
>> The only obstacle to this is a good way to share antennas without
>> transmit power from the main radio destroying the SDR receiver. Some
>> main radios offer a receive out and receive in loop so with those
>> radios it is a simple setup.
>>
>> For radios that don't have a good way to share antennas, several
>> companies offer solutions. For example, one such solution is the
>> DXE-RTR-1A from DX Engineering.
>>
>> Carl Moreschi N4PY
>> 58 Hogwood Rd
>> Louisburg, NC 27549
>> www.n4py.com
>>
>> On 1/29/2017 9:57 PM, km2km at twc.com wrote:
>>> After reading the Panadaptor article in the FEB 2017 QST I'd like to
>>> try that with my Delta II
>>>
>>> Has anyone done this? Where is the tap for the IF?
>>>
>>> Suggestions?
>>>
>>> 73
>>> Kris KM2KM
>>> MERSCHROD
>>> 123 Warren Road
>>> Ithaca, NY 14850
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


More information about the TenTec mailing list