[TenTec] notch filter for Eagle?

Michael Tortorella w2iy at verizon.net
Wed Jul 19 15:05:59 EDT 2017

Hi all, I am hearing an awful lot of steady carrier signals up here in the
frozen north of Downeast Maine.   Most are not very strong and they go away
when I disconnect the antenna so they are external to the radio.  Today I am
chasing TR8CA on 20 CW, he is way down in the noise, and 100 Hz away from
one of these carriers.  Sure would be nice to have something like a notch
filter to help in situations like these but I could not see anywhere in the
manual or front panel where I could notch the offending carrier.  Is there
any list wisdom on this?  


On another note, I did contact service at TT last week with my question
about power out in autotune; after only a few days delay I got an answer
that the power out in autotune is 20 watts even though the power output
shown on the display is 100.  This seems not quite right from a human
factors point of view, maybe there can be a firmware fix?  Also, when
exchanging VFOs, the A,B labels do not change even when the B vfo is in
large type at the top of the display.  I find this confusing.  OK, I guess
this turned into a longer letter about a couple of other things besides
notch filtering, so please excuse my prolixity and thank for the BW.  Any
suggestions appreciated.

Thanks and 73, Mike W2IY 

This email has been checked for viruses by AVG.

More information about the TenTec mailing list