[TenTec] Omni VI questions

[Dukes HiFi]

If it’s off on all bands by the same amount, you might consider adjusting the reference oscillator.

Gary



> On Jul 30, 2017, at 3:57 PM, Joe Papworth via TenTec <tentec at contesting.com> wrote:
> 
> Barry is Da Man!
> <span style="font-size: 16px;">
> </span><div>I agree with leaving well enough alone
> on the 20 and 40 hz problem.
> 
> My Omni 6 Plus was always dead on until I had to do some work on the Osc. board a year or so ago.
> 
> It's now 20 hz off on all bands and modes but it's operationally perfect otherwise and I'm not gonna tempt OM Murphy.
> 
> 
> Sent from AOL Mobile Mail
> 
> 
> -----Original Message-----
> From: Stan Gammons <s_gammons at charter.net>
> To: tentec <tentec at contesting.com>
> Sent: Sun, Jul 30, 2017 03:41 PM
> Subject: Re: [TenTec] Omni VI questions
> 
> 
> On 07/30/2017 02:04 PM, Barry N1EU wrote:
>> Stan, if the 288 filter is plugged into your 9MHz i.f. board, remove it and
>> install it properly on the PBT board.  That is a 6.3MHz i.f. filter.
>> 
>> 73, Barry N1EU
>> 
>> 
> 
> Hi Barry,
> 
> Yep, it looks like someone put that filter in the wrong slot.  I put it 
> on the PBT board and the 1.8 Khz bandwidth setting works now. Thanks!
> 
> I sent a message to the list with a pic of the 2 filters attached. But, 
> it was too large and got put on hold.
> 
> Thanks again for your help.
> 
> 
> 73
> 
> Stan
> KM4HQE
> 
> _______________________________________________
> TenTec mailing list
> <a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a>
> <a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
> </div>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec