[TenTec] 962 power supply {was 961 PWR Supply}

[Robert S Jenkins]

Those values were with the bridge completely out of the circuit. 

Why did you mount it on the back of the front panel?

Tnx,

Robert
KG4KGL

> On Jun 27, 2017, at 13:25, Joe Papworth via TenTec <tentec at contesting.com> wrote:
> 
> If the bridge is still in the circuit, that .2 ohm reading is the secondary winding of the transformer.
> If it does end up being the bridge, I recommend you remotely mount the new one somewhere. I put mine on the back side of the front panel. Use BIG wire. (At least 12 gauge)
> And use heat sink grease.
> 
> Sent from AOL Mobile Mail
>