[TenTec] 962 power supply {was 961 PWR Supply}

[Curt Gamble]

Radio Shack in Derby Kansas (Wichita) is still viable and carries lots 
of stock,  plus lots of Ham gear.

Phone # 316 788 4225    Mgr is Mark Brecheisen  KBØMOF

73,  Curt  WØALC  in CO


On 6/27/2017 12:29 PM, Joe Papworth via TenTec wrote:
> PS- Radio Shack used to stock the 25 amp version in their stores. Some of them may still have it.
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Joe Papworth via TenTec <tentec at contesting.com>
> To: tentec <tentec at contesting.com>
> Cc: k8mp <k8mp at aol.com>
> Sent: Tue, Jun 27, 2017 02:09 PM
> Subject: Re: [TenTec] 962 power supply {was 961 PWR Supply}
>
>
> It was a long time ago but it was probably the only place I found room. Or it could have been an existing screw or stud.
> That bridge is toast.
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Robert S Jenkins <<a href="mailto:qrp at kg4kgl.net">qrp at kg4kgl.net</a>>
> To: Discussion of Ten-Tec Equipment <<a href="mailto:tentec at contesting.com">tentec at contesting.com</a>>
> Sent: Tue, Jun 27, 2017 01:31 PM
> Subject: Re: [TenTec] 962 power supply {was 961 PWR Supply}
>
>
> Those values were with the bridge completely out of the circuit.
>
> Why did you mount it on the back of the front panel?
>
> Tnx,
>
> Robert
> KG4KGL
>
>> On Jun 27, 2017, at 13:25, Joe Papworth via TenTec <<a href="<a href="mailto:tentec at contesting.com">tentec at contesting.com</a?">mailto:tentec at contesting.com">tentec at contesting.com</a</a>>> wrote:
>>
>> If the bridge is still in the circuit, that .2 ohm reading is the secondary winding of the transformer.
>> If it does end up being the bridge, I recommend you remotely mount the new one somewhere. I put mine on the back side of the front panel. Use BIG wire. (At least 12 gauge)
>> And use heat sink grease.
>>
>> Sent from AOL Mobile Mail
>>
> _______________________________________________
> TenTec mailing list
> <a href="<a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a?">mailto:TenTec at contesting.com">TenTec at contesting.com</a</a>>
> <a href="<a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>" target="_blank"><a href="http://lists.contesting.com/mailman/listinfo/tentec</a" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a</a>>
> _______________________________________________
> TenTec mailing list
> <a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a>
> <a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>