[TenTec] Orion II Power Connector Replacement

Rod Greene w7zrc at yahoo.com
Thu Mar 2 11:11:37 EST 2017


I ordered the little plates to mount the power pole connectors on the back of the Orion. Any suggestions on the process of installing the power poles that way would be appreciated and for bypassing the fuse. 

Thanks again and 73, Rod/w7zrc

      From: Rod Greene via TenTec <tentec at contesting.com>
 To: denton sprague <denton at oregontrail.net>; Discussion of Ten-Tec Equipment <tentec at contesting.com> 
Cc: Rod Greene <w7zrc at yahoo.com>
 Sent: Wednesday, March 1, 2017 1:51 PM
 Subject: Re: [TenTec] Orion II Power Connector Replacement
   
I agree, it looks pretty flimsy, so think I will bypass and use a different fuse.
Thanks and 73, Rod/w7zrc


      From: denton sprague <denton at oregontrail.net>
 To: Rod Greene <w7zrc at yahoo.com>; Discussion of Ten-Tec Equipment <tentec at contesting.com> 
 Sent: Wednesday, March 1, 2017 8:17 AM
 Subject: Re: [TenTec] Orion II Power Connector Replacement
  
take a gander at that little fuse holder while you are in there….kinda puny in my observation. 
when I redo my Oroin 1, I will bypass that fuse holder with a big fuse holder on a new power cords pigtail.
> On Mar 1, 2017, at 6:25 AM, Rod Greene via TenTec <tentec at contesting.com> wrote:
> 
> 
> 
> 
> I'm pretty sure I've got the bad power connector problem. Rig intermittently gives a loud "POP" and then reboots. What's the best recommended solution? Solder the power cable directly to the board without the molex connector - or - do the power pole replacement? I'm leaning to the direct wire mod.
> Suggestions please! Thanks and 73, Rod/w7zrc
> 
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


  
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


   


More information about the TenTec mailing list