[TenTec] Omni 6 Plus problem

[Dukes HiFi]

Check for connectors that are one pin off.

That is the most frequent thing that happens when folks “reseat connectors”.

Gary

W0DVN
> On May 24, 2017, at 8:10 PM, Michael Marx <sndtubes at vacuumtubes.com> wrote:
> 
> Hi guys,
> 
> Unfortunately, my newly acquired Omni 6+ just “blew up”.  It was working fine.  Then I noticed the display was a missing digits and segments.  I figured I just needed to re-seat the connectors which I did.  When I turned it back on, the dial lights flashed up brightly and then dimmed.  At that point, all of the LED’s on the panel were lit and nothing else.  Any suggestions on what I should do now?
> 
> 73
> Mike WB0SND
> 
> 
> Michael Marx
> sndtubes at vacuumtubes.com
> 636-939-9190
> 
> 
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec