[TenTec] Omni 6+ Confusion

[Barry N1EU]

http://tentecwiki.org/doku.php?id=564

under "Mods, Fixes, & Additional Info" scroll down to bottom line

73, Barry N1EU

On Mon, Oct 23, 2017 at 9:51 PM, Ken <kakoval at cox.net> wrote:

> Today I finally got around to replacing the crystal oven on my Omni 6+
> Logic Board with a brand new oven.  Not a bad job, but when I put the Logic
> Board back in and started connecting everything, I ran into a problem.
> Cable 41A has 3 pins and cable 34 has 2 pins.  However, the header that
> they mate with has 6 pins, one extra.  I know I should have noticed this
> when I took the board out, but I didn't.  Now I'm confused as to how to
> connect cables 41A and 34 back to the board.  The schematic in the manual
> is no help.  Any help to un-confuse me would be greatly appreciated.
> Thanks...Ken,  K9PGC
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>