[TenTec] Paragon 585 com port control?

[Hal]

rod,
I never even tried to do anything with computers.
don't know if it does that or not.
I'll leave that to the experts to answer.


Have fun,
Hal   AA2ID



-----Original Message-----
From: Rod Greene via TenTec <tentec at contesting.com>
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Cc: Rod Greene <w7zrc at yahoo.com>
Sent: Mon, Sep 4, 2017 3:10 pm
Subject: Re: [TenTec] Paragon 585 com port control?

Thanks again for the thoughts (Hal).. I'm wondering what software will control the Paragon via the com port? I checked HRD and N1MM+ and neither has Paragon listed as transceivers in their lists for radio setup and connection. Perhaps it would work with the Omni VI selection? I downloaded a manual copy but it doesn't contain any information about the command set for control. Thanks again and 73, Rod/w7zrc      From: Rod Greene via TenTec <tentec at contesting.com> To: Rod Greene <w7zrc at yahoo.com>; Discussion of Ten-Tec Equipment <tentec at contesting.com> Cc: Rod Greene <w7zrc at yahoo.com> Sent: Monday, September 4, 2017 12:02 PM Subject: Re: [TenTec] Paragon 585   Well I finally got the power supplies back in operation, so took a shot at the Paragon this morning and the preliminary results are good. Full operation of all the controls except I haven't tried the keypad settings on the right yet. Also full power out on all bands and it sounds good on a second receiver (cw only so far). Next I will hook it up to an antenna and see how it plays on the air. So far it was just on a dummy load/power meter. Thanks again for the suggestions.73, Rod/w7zrc      From: Rod Greene via TenTec <tentec at contesting.com> To: Discussion of Ten-Tec Equipment <tentec at contesting.com> Cc: Rod Greene <w7zrc at yahoo.com> Sent: Sunday, August 27, 2017 3:12 PM Subject: [TenTec] Paragon 585  All, I recently picked up a Paragon at a swap meet. It's really dirty and probably hasn't been turned on in awhile. Any precautions or suggestions before (and as) I put power to it and start checking it out? Condition: One small cut out in the top panel and it has all the filter slots filled. Looks complete and good otherwise.Thanks and 73, Rod/w7zrc_______________________________________________TenTec mailing listTenTec at contesting.comhttp://lists.contesting.com/mailman/listinfo/tentec  _______________________________________________TenTec mailing listTenTec at contesting.comhttp://lists.contesting.com/mailman/listinfo/tentec _______________________________________________TenTec mailing listTenTec at contesting.comhttp://lists.contesting.com/mailman/listinfo/tentec