[TenTec] Omni VI

[Malcolm McLeman]

Thanks yours Barry regrettably my test equipment is very limited and looking inside the O-6 certainly looks a lot more formidable than my dear old Corsair2 along with the added problem of age (78) and failing eyesight say no more...
Will have a go at the receive chain simply bridging the antenna by following the diagram.. 
Bear with me..
73 

Malc/F5VBU 
 

  ----- Original Message ----- 
  From: Barry N1EU 
  To: Discussion of Ten-Tec Equipment 
  Sent: Thursday, September 07, 2017 4:13 PM
  Subject: Re: [TenTec] Omni VI


  Are you able to inject a 50uV signal into the antenna jack and trace it
  down the receive chain? Do you you have test equipment?

  Barry N1EU

  On Thu, Sep 7, 2017 at 9:59 AM, Malcolm McLeman <f5vbu at cegetel.net> wrote:

  > For inclusion in the TenTec Omni VI forum...
  >
  > Comparing normal band condx with my FT102, my Omni VI receiver has
  > suddenly died though the transmit side works as per normal..
  > I can also pick up the cw output from a very QRP signal from my FT102..
  > Have tried all the usual permutations with antenna connections etc Omni
  > factory reset and dc check on the T/R relay on the band-pass filter board..
  > I'm rather stuck on where to go next and wondered if any-one may have an
  > answer..
  > 73
  >
  > Malc/F5VBU
  >
  > NNNN
  > _______________________________________________
  > TenTec mailing list
  > TenTec at contesting.com
  > http://lists.contesting.com/mailman/listinfo/tentec
  >
  _______________________________________________
  TenTec mailing list
  TenTec at contesting.com
  http://lists.contesting.com/mailman/listinfo/tentec