[TenTec] Filters

[Ken Brown]

If you have not already tried it, I would suggest you reflow all the solder
connections on that filter. It may recover.

DE N6KB

On Tue, Sep 12, 2017 at 4:56 PM, Stan Gammons <s_gammons at charter.net> wrote:

> I finally got around to doing a sweep of the filters on the PBT board in
> my Omni VI using the Midnight SNA.  I think I see why the signal level
> shown on the S-meter increases when I switch from 2.4 Khz to 1.8 Khz.  The
> 2.4 Khz filter has like 9 to 10 db more loss than the 1.8 Khz or 500 Hz
> filters.  The extra 1.8 Khz and 500 Hz filters I have all measured roughly
> the same.  I don't have another 2.4 Khz filter to compare to.  Guess I need
> to find another one.
>
>
> 73
>
> Stan
> KM4HQE
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>