[TenTec] Orion problems

[Steve]

The A9 board has been updated.  Since there is output from the rcvr to
the Logic board and no audio out of any kind it makes me wonder about the
DSP and CODECS on that board.  I went and loaded Ver 1 software but that
made no difference either.

Steve

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Peter
Frenning [OZ1PIF]
Sent: Monday, September 25, 2017 5:15 PM
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>; Steve
<sswhite at mchsi.com>
Subject: Re: [TenTec] Orion problems

Den 25-09-2017 kl. 22:31 skrev Steve:
> Orion 1..Battery is good too...I wonder if I can put a 14 Khz 
> unmodulated signal into the DSP input  (J20) and find out if the whole 
> DSP chain is working..
>
> Steve
Has anybody suggested checking out the A9 board? Any of a whole box of
Gremlins can emerge from troubles there. When mine (O2) started acting
erratically I updated the thre 470uF electrolics to lower ESR/higher temp
ones, and all my troubles went away, many other similar experiences has
been related here over time.

-- 
Vy 73 de OZ1PIF/5Q2M, Peter

******************************************
** The day Microsoft makes something	**
** that doesn't suck is probably the 	**
** day they start making vacuum		**
** cleaners ! 				**
**      	-- Anonymous Wise Guy	**
******************************************
email: peter(no-spam filler)@frenning.dk
http://www.frenning.dk/oz1pif.htm
Ph. +45 4619 3239/ +45 2332 9464
Snailmail:
Peter Frenning
Ternevej 23
DK-4130 Viby Sj.
Denmark
******************************************

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec