[TenTec] Omni VI Plus front panel issue

[MadScientist1948]

Those four LED’s are common to connector 96.

The LED’s share a ground one end of tat connector. Since all 4 are intermittent, I would focus on that ground connection, on both ends of the cable, and also check the integrity of the white connectors on both ends of the connecting cable as the also come loose sometimes.

Gary

> On Apr 23, 2018, at 11:16 AM, Gary Hendricks <k4mt1950 at charter.net> wrote:
> 
> I have one problem on my Omni VI Plus that I cant locate. When I press
> MS or MT or LP or NR the lights next to the buttons do not light or at
> times if I press NR the MS light comes on or when I press MS NR comes
> on and other times no lights come on at all.
> The buttons are performing the proper task IE NR does NR and MS does
> MS even if the wrong led is lit.
> I pulled and re-seated all the connectors on the front panel and did
> hard reset and even pulled battery but still the same. Has anyone seen
> this behavior?
> I even pulled front panel and re-solderd all the pins and checked for
> cold solders etc but all looke fine.
> Gary K4MT
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec