[TenTec] Omni VI Plus front panel

[k4mt1950 at charter.net]

Yes I saw that page but if diodes in diag are supposed to be the leds
there is none for LP or NR. Can not find those LEDS referenced
anywhere
Gary K4MT

	-----------------------------------------From: "Barry N1EU" 
To: "Discussion of Ten-Tec Equipment"
Cc: 
Sent: Monday April 23 2018 2:02:30PM
Subject: Re: [TenTec] Omni VI Plus front panel

 The buttons/switches are shown in figure 4-34 on page 4-33

 Barry N1EU

 On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks 
 wrote:

 > I can not find a schematic that shows the MS MT LP AND NR buttons
and
 > where they go to on I assume the logic board. Anyone know where
that
 > schematic might be found
 > Gary K4MT
 > _______________________________________________
 > TenTec mailing list
 > TenTec at contesting.com
 > http://lists.contesting.com/mailman/listinfo/tentec
 /> >
 _______________________________________________
 TenTec mailing list
 TenTec at contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
 />