[TenTec] Omni VI Plus front panel

[MadScientist1948]

Congratulations on a good repair!

Gary

> On Apr 23, 2018, at 3:46 PM, k4mt1950 at charter.net wrote:
> 
> Barry:
> I found the problem. Conn 96 now feeds the leds I was talking about.
> The plug on the logic board someone had plugged in a pin off
> Now all is well
> Thanks
> Gary K4MT
> 
> 	-----------------------------------------From: "Barry N1EU" 
> To: "Discussion of Ten-Tec Equipment"
> Cc: 
> Sent: Monday April 23 2018 2:09:21PM
> Subject: Re: [TenTec] Omni VI Plus front panel
> 
> The lines come into the logic board on the bottom right side of the
> schematic (p 4-20) - connectors 91 and 92
> 
> Barry N1EU
> 
> On Mon, Apr 23, 2018 at 8:02 PM, Barry N1EU  wrote:
> 
>> The buttons/switches are shown in figure 4-34 on page 4-33
>> 
>> Barry N1EU
>> 
>> On Mon, Apr 23, 2018 at 6:30 PM, Gary Hendricks 
>> wrote:
>> 
>>> I can not find a schematic that shows the MS MT LP AND NR buttons
> and
>>> where they go to on I assume the logic board. Anyone know where
> that
>>> schematic might be found
>>> Gary K4MT
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
> /> >>
>> 
>> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> />
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec