[TenTec] zero adjust S meter in Orion II

[Troy, W6HV]

Thanks, Mike. I have that calibration procedure, but the S meter is way high and I need to put it back to zero when there is no signal present (short out the ant input). I should have been more explicit in my cry for help.
73,
Troy, W6HV

-----Original Message----- 
From: Mike Pagel 
Sent: Tuesday, April 24, 2018 4:12 PM 
To: 'Discussion of Ten-Tec Equipment' 
Subject: Re: [TenTec] zero adjust S meter in Orion II 

http://www.tentec.com/wp-content/uploads/2016/05/S-Meter_565_566_Calibration_Procedure.pdf

73, de Mike, K9UW
Amherst, WI

-----Original Message-----
From: TenTec <tentec-bounces at contesting.com> On Behalf Of Troy, W6HV
Sent: Tuesday, April 24, 2018 5:44 PM
To: tentec at contesting.com
Subject: [TenTec] zero adjust S meter in Orion II

I can't recall (or find) the way to zero the  S meter in my Orion II.  I have the procedure for calibration. Any help?

Thanks,

Troy, W6HV

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec