[TenTec] centurion

[Mcelmer1]

Rodney,

With no drive and cherry red, Houston, we have a problem. Short somewhere, 
been there done that with the Centurion but mine was drawing about 50 - 75 
ma.

Perhaps I a missing part of conversation. Is this 190ma with no drive??

Other friends of mine have been thru this with the 3-500s: no drive but 
tube(s) drawing current.

Mike
W8TRN

Mike
W8TRN
----- Original Message ----- 
From: "Rodney" <w3krq at dejazzd.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, August 08, 2018 19:28
Subject: Re: [TenTec] centurion


> no it was 190 m with no drive and tubes got red
>
> -----Original Message----- 
> From: Bob McGraw K4TAX
> Sent: Wednesday, August 08, 2018 8:53 PM
> To: tentec at contesting.com
> Subject: Re: [TenTec] centurion
>
> Is this idle current with no signal?   If so it is about correct.
>
> 73
>
> Bob, K4TAX
>
>
> On 8/8/2018 7:42 PM, Rodney wrote:
>> I was on my Centurion talking and looked at my plate current it was 
>> resting at 190m but the amp was putting out 1200w so tubes I think are 
>> ok.
>>
>> ---
>> This email has been checked for viruses by AVG.
>> https://www.avg.com
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec