[TenTec] FS: Omni V, VI, VI+ Inrad roofing filter kit

[Greg S]

Yup. Thanks, Barry. Pretty easy install. Solder 1 wire to an existing resistor lead, and install a ground lug under a corner screw on one board. The rest are plug in connectors. In case anyone was curious.

Greg, KC8HXO 

Sent from my Linux device

> On Aug 14, 2018, at 20:35, Barry N1EU <barry.n1eu at gmail.com> wrote:
> 
> It goes between the BPF/Front End Board's RX IF OUT and the 9MHz Xtal
> Filter Board's RX IN  (cable "25")
> 
> Barry N1EU
> 
> On Tue, Aug 14, 2018 at 11:46 PM, Curt Benjamin via TenTec <
> tentec at contesting.com> wrote:
> 
>> Greg, where in the Omni VI circuitry does that filter go?
>> Curt, K8AI
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec