[TenTec] Scout Frequency Error

MadScientist dukeshifi at comcast.net
Tue Dec 25 23:30:11 EST 2018


Well, each band model has its own crystal local oscillator. The chance of their all being off 100 Hz is zero.

The PTO can be off, there is a cal process for this - it would affect all bands the same amount. However, since the counter reads the PTO, it automatically corrects for PTO errors.

Ditto for the BFO.

Therefore it is likely that the timebase oscillator for the display is out of calibration.

Alignment is easy, as shown in the manual.

> On Dec 25, 2018, at 10:16 PM, Winston <jones_winston at bellsouth.net> wrote:
> 
> I don’t do a lot of cw, only noticed it on SSB, when on a net with my readout 100 Hz above other stations on same frequency. 
> 
> Sent from my iPhone
> 
>> On Dec 25, 2018, at 10:49 PM, Peter Bertini <radioconnection at gmail.com> wrote:
>> 
>> As you just described the problem as needing to do a 100 Hz offset sounds
>> more like an error in the CW BFO settings or something related to whatever
>> gives the CW offset in that rig.
>> 
>> Pete
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list