[TenTec] TenTec] Omni VI+: low TX and RX on 12 meters

[Phil Erickson]

Hi Peter,

  I'll check that next, but I'm a bit mystified if this is the problem
since I see there are only 6 LPFs in the bank.  So I'm not sure why I would
be getting full power on 15 and 10 meters but not 12 if one of the relays
was not working.  (It would have made more sense to see that e.g. 12 and 10
meters were low output because they were going through the same faulty path
to a LPF.)

  Also, the 20 dB less sensitivity on RX is not related to any of this,
correct?

73
Phil W1PJE


On Thu, Dec 27, 2018 at 6:42 PM Peter Bertini <radioconnection at gmail.com>
wrote:

> Most likely a bad relay in the transmitter low pass filter bank..
>
> Unlocked HFO does not cause low power, just a few kHz error and a warbly
> signal.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>