[TenTec] Omni VI+: low TX and RX on 12 meters

[MadScientist]

A decent scope would do fine. The frequency here is never greater than 39 MHz.

Gary

> On Dec 27, 2018, at 7:27 PM, Peter Bertini <radioconnection at gmail.com> wrote:
> 
> As far as receive, the last low pass filter covers from 22 to 30 MHz, so if
> ten meters works that rules out a relay problem.  You can verify relay
> select voltage for both 10 and 12 meters on the last pin of J14. A bad "or"
> steering diode could drop a band, but that is not likely.
> 
> As Gary suggested, check the soldering  where he advised to do so.
> 
> Being able to measure  The last miserable project Omni VI I undertook had a
> bad solder joint in one of the bandpass filters on the LO Mixer board. Low
> LO on RX and TX, low power and very deaf RX.  I suspect measuring the LO
> level on Jack 26 for each band might give a clue if you have a RF
> milli-voltmeter or milli-watt meter.
> 
> Pete
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec